Raymarine eci-100 - Tools Required; Typical Systems

3.7Toolsrequired
Productinstallationrequiresthefollowingtools:
ItemDescriptionQuantity
Powerdrill1
Pozidrivescrewdriver1
Drillbitofappropriatesize*
1
Note:*Theappropriatedrillbitsizeisdependentonthe
thicknessandmaterialofthemountingsurface.
3.8Typicalsystems
Important:DoNOTconnect2ormoreECIunitstothesame
engineCANbus.
Example:basicsystem—engineinterfaceonly
Intheexamplebelowtheunitisusedasanengineinterface
only,theunitwillinterfacewithallenginesonthesameCAN
bus.Inthiscongurationtheunitcannotcontrolthevessel’s
steeringsystem.
12 V dc
SeaTalk
ng
D12969-1
5
3
2
1
4
Note:Theillustrationaboveshowsthevariousproductsthat
canbeconnectedinatypicalsystem.Forinformationonhow
toconnecttheproducts,refertotheChapter4Cablesand
connectionssection.Forinformationonavailablecablesand
accessories,refertotheChapter10Sparesandaccessories
section.
ItemDescription
1
Multifunctiondisplay
2
Vesselengine(s)(Connectiontoengine’sCANbus)
3
Engine-specicadaptorcable
4
ECIunit
5
SeaTalk
ng
5–wayblock
Example:IndependentengineCANbusnetworks
Onamulti-enginevesselthathasdedicatedCANbusnetworks
foreachengine,then1unitpernetworkisrequired.
12 V dc
SeaTalk
ng
SeaTalk
ng
D12970-1
5
3
2
2
1
4
3
4
Note:Theillustrationaboveshowsthevariousproductsthat
canbeconnectedinatypicalsystem.Forinformationonhow
toconnecttheproducts,refertotheChapter4Cablesand
connectionssection.Forinformationonavailablecablesand
accessories,refertotheChapter10Sparesandaccessories
section.
Planningtheinstallation
15