To enter the active page: Press the button. A list of parameters and
current settings is displayed with the active parameter over the cursor .
Press the button to return to the list of pages.
To change the active parameter: Press the button repeatedly until
the desired parameter title is over the cursor .
To edit a numeric parameter value: Press the button. The value data
will begin to flash. Use the and buttons to adjust the value. Press
the button again to set the new value.
To reset a memory value: Press the button.
To select a parameter option from a list: Press the button. The
parameter option will begin to flash. Use the and buttons to select
the option required. Press the button again to set the new option.
To toggle between ON/OFF parameter settings: Press the button.
Troubleshooting
Lost Network Alarm sounds:
Check that the master display is working correctly and that the
affected display(s) are within range.
No Volts alarm sounds:
Check that the Hull Transmitter and Wireless (NMEA) interface
are connected to a 9 to 30V DC supply.
Low Battery Alarm sounds:
Go to Setup/Health and check the battery level for the Hull
Transmitter/Wireless (NMEA) Interface/Wind Transmitter as
indicated by the alarm display. Charge or place in bright sunlight
if required.
Power Save Alarm sounds:
There is no data activity on the network, the system will close
down to save power. Press any button to cancel.
Quick start guide for Remote Display
6
www.raymarine.com
To Next Page
Loading...
