Operation
15
www.raymarine.com
25 TTG (Time to go to waypoint)
The calculated time remaining before you will arrive at the
(active) waypoint as calculated by a GPS receiver or plotter.
26 SEA (Sea temperature)
Current sea temperature as measured by the sensor in the
Speed Transducer.
Displayed in the current temperature units.
See p 23 S13 to select units.
27 RACE TIMER
Countdown and elapsed time clock.
The timer can only be set and operated in single item display
mode. In 4 line display mode the current state of the count
down or elapsed time can be viewed but not modified.
To set the countdown period:
Press and hold for 1 second the button.
Use the and buttons to set the required countdown time in
minutes.
Press the button quickly to prepare to start the countdown.
To operate the timer:
Press the button quickly to start the countdown.
The display will sound a single beep every 60 seconds until 1 minute
remains when a beep will sound at 10 second intervals. The final 10
seconds will count down with a beep each second with "START" being
indicated by a triple quick beep at 0 seconds.
At any time during the countdown a quick press of the button will
re-synchronise the timer to the nearest minute and commence
countdown from that point.
After the countdown is completed, the timer will automatically start to
count the elapsed time and this will continue until the button is
pressed and held for 2 seconds.
To Next Page
Loading...
Need help?
General
