Chapter 2: Getting Started & Adjusting the Display 2-3
Switching the Display
On and Off
➤ To switch the radar scanner from Stand-by mode to Transmit mode, press the
POWER key.
The scanner transmits pulsed energy while it rotates, and the antenna sweep
builds up the radar picture using echoes returned from targets.
Figure 2-2: Radar Transmit Mode
➤
You can switch on and adjust the display backlighting and, on the mono
display, contrast, as described later in this chapter.
➤ To switch to Stand-by mode, press the POWER key.
The display returns to the Stand-by screen, and the scanner transmission and
rotation stops.
➤ To use Scanner off mode:
1. Ensure that the radar is in Standby mode, warming up, or displaying a mes-
sage that radar data is not available.
2. Press the
CLEAR key. The message STANDBY. RADAR DATA NOT AVAILABLE
appears in the radar picture. The scanner is powered down and the timer, if
running, is cleared.
To return to radar operation, press the
POWER key. The warm-up countdown
is displayed and the radar goes into Standby mode. You press
POWER again to
switch to Transmit mode when required.
To Next Page
Loading...
