Chapter 6: Installation 6-1
Introduction
Chapter 6: Installation
6.1 Introduction
This chapter provides installation instructions for your SL70 PLUS series
display. Details for mounting the SL70 PLUS series display and connecting
the equipment are included. A typical system is illustrated in Figure 6-1.
• To install the display unit follow the instructions in Section 6.2 to
Section 6.6.
You should then test the display as described in Section 6.7.
• To connect your display to other equipment, follow the guidelines in
Section 6.8 and Section 6.9, taking particular care to ensure the correct
polarity of the SeaTalk supply.
• Details on installing the scanner are provided in the Pathfinder Plus
Radar Scanner Owner’s Handbook.
Figure 6-1: Typical System
Note: If you wish to practice using the display before installation, connect a
12V or 24V DC power supply (connecting the red wire via a 6.3A quick blow
fuse to positive and the black wire to negative) and using the simulator mode,
as described in Chapter 2.
NMEA
SeaTalk
Display Unit
Distribution Panel
D4288-2
Scanner
12/24V Supply
12V Supply
12V Supply
Junction
Box
GPS
Compass
To Next Page
Loading...
