Chapter 2: Getting Started & Adjusting the Display 2-11
Customizing the
Screen Presentation
Options
At any time, you can switch the group of data boxes on or off using the SCREEN
soft key. When first installed, the boxes are all OFF. When the display unit is
switched off and on again, the data boxes return to their last-used states (
ON or
OFF) and positions.
Note: The
SCREEN soft key does not control the nine or sixteen data boxes that
can be displayed in the half-screen window.
➤ To switch the group of data boxes on or off:
1. Press the
SCREEN default soft key.
2. Press the
DATABOXES soft key to toggle the setting from ON to OFF or from
OFF to ON.
To return to the default soft key display, press
ENTER.
If you turn the data boxes on and none are displayed, you need to select the
ones you require using the system set up menu, as described in Section 5.3,
System Set Up Parameters.
➤ You can use the context sensitive cursor to select and move any data box (the
label
BOX is displayed). See Moving and deleting items with the context-
sensitive cursor on page 1-10
Waypoint Display
If you are currently going to a waypoint, you can display the active waypoint
on the radar picture. The waypoint may have beenreceived via the SeaTalk or
NMEA interface.
➤ To display the active waypoint:
1. Press the
SCREEN soft key.
2. Press the
WAYPOINT soft key to toggle the setting ON.
To return to the default soft key display, press
ENTER.
The standard radar picture is displayed again, with the active waypoint joined
to your vessel’s position by a dotted line. If the waypoint is off-screen, the
dotted line is extended to the edge of the radar picture.
Figure 2-5: Active Waypoint on a Radar Display
SCREEN
SCREEN
DATABOXES
OFF ON
BOX
SCREEN
WAYPOINT
OFF ON
D3989-2
Active waypoint
To Next Page
Loading...
