Chapter 5: Setting Up the System Defaults 5-3
Changing the Set Up
Parameters
required setting is displayed. This setting is retained when you move the
selection bar on to the next parameter in the menu list.
For sliders, press the appropriate soft key repeatedly to increase or
decrease the slider value in individual steps, or press and hold the key to
change the setting quickly.
5. Once you have set all the required values, press
ENTER to clear the menu
and return to the set up soft keys.
6. Press
ENTER, MENU or CLEAR to clear the soft keys and return to the
default display.
You can return all the settings to their original factory settings, if required, by
performing a factory reset as described in Chapter 7.
To Next Page
Loading...
