Raymarine SmartPilot Series - H O W D O I R E T U R N T O H a N D S T E E R I N G; H O W D O I C H a N G E C O U R S E I N a U T O M O D E

Chapter 1: Basic operation 7
3. Press auto .
T he SmartPilot is now in AUTO mode and will steer to the chosen heading,
shown o n the display . This mod e is often known as “pointandshoot”.
How do I return to hand steering?
1. Press standby to disengage th e SmartPilot:
•in STANDBY mode , you have manual control of the boat and the display
shows the bo at’s current compass head ing.
2. Diseng age the autopilot to return to hand steeri ng:
• Wheel Pilot: Disengag e the wheel drive clutch by rotating the clutch
lever ant iclo ckwise (so t he lever engages fully onto th e locating pip ).
• Tiller Pilot: Remove the drive unit from the til ler pin. If required, retract
the push rod using
1 , +1 , 10 and +10 keys.
CAUTION: Wheel drive syst ems
On wheel drive systems, always make sure that the clutch is FULL Y
DISENGAGED befor e you leave the boat.
How do I change course in Auto mode?
In Au to mode , use the 1 and 10 (port) and +1 and +10 (starboard) butt ons to
change the locked heading in steps of 1° or 10°. For example: press
10 three
times for a 30 ° course change to port.
D3560-6
TRUE
D3561-6
TRUE
81283_1.book Page 7 Monday, October 2, 2006 2:03 PM