52 ST1000 Plus & ST2000 Plus Tiller Pilots
If the display continues to show a flashing ‘C’ and the current heading, the tiller
pilot is not receiving any wind data. The most likely reason is a cabling error –
either open circuit, short circuit or wires reversed.
Checking the SeaTalk interface
If you have linked the tiller pilot to other instruments or control units via SeaTalk,
check the link as follows:
1. Press
standby.
2. Select display illumination level 0 (LAMP 0) on any other SeaTalk instrument
or autopilot control unit.
D3270-2
D3271-2
D170-2
81130_5.book Page 52 Wednesday, June 15, 2005 3:48 PM
To Next Page
Loading...
