12 ST60 Graphic Display Commissioning Guide
Self test
Self test is intended for engineers engaged in diagnostic procedures. Always
set this to NO.
Note: If YES is selected, you could inadvertently initiate a self test routine.
This will not harm the product but will interrupt operation, so it is therefore
NOT recommended.
Depth units Feet
Speed units Knots
Wind speed units Knots
Variation None
Alarms All enabled
User calibration Enabled
Depth response 12
Speed response 12
Heading response 12
Wind angle response 12
Wind speed response 12
VMG response 12
COG/SOG response 12
Alarm control On
NMEA Off
Auxiliary alarms All off
Low voltage threshold Off
Display contrast 40
Pilot pop-up Off
Waypoint identity Name
Time offset 0 (zero)
Chapter titles On
Remote group None
Remote sequence None
Parameter Factory default
81228_1.book Page 12 Wednesday, November 19, 2003 10:29 AM
To Next Page
Loading...
