WR14 / WR50-12/13 Winding Resistance Meter Instruction Manual
Create a new Profile
Press new on the tab "Active." A message appears asking if you want to create a completely new
transformer Profile or just make a new measurement under the Active Profile.
Select "New Transformer."
First select the configuration of the Primary winding of the transformer. Choose the corresponding
configuration of your transformer’s Primary side from the Setup menu shown below. After selection, the
instrument will display the Primary configuration in the highlighted box and automatically move to the
next highlighted box to select the Secondary winding of the transformer.
Winding configurations set here
To Next Page
Loading...
