WR14 / WR50-12/13 Winding Resistance Meter Instruction Manual
Taps:
Tap changer positions can also be defined for every winding system.
Touch the check box beside the text "No. Tap"
(Number of Taps) below the transformer coil that
you wish to enter the number of Tap positions.
A screen appears to allow the setting of the number of tap changer position steps.
Use the arrows "<" or ">" to increase or decrease
first and last tap steps.
The First Tap setting (-2 shown): Lower Taps
The Last Tap setting (5 shown): Upper Taps
The total number of Taps selected will be displayed
above OK.
Confirm with OK to set (e.g. 8) Taps. View the number of Taps in this Transformer setup screen.
Your Transformer may have Tap positions on the
Primary and on the Secondary windings. Use the
same procedure to define the Secondary Tap
positions.
To Next Page
Loading...
