WR14 / WR50-12/13 Winding Resistance Meter Instruction Manual
Template Profiles can be cloned in the Archive
menu. The instrument creates a Transformer Profile
based on the template.
Highlight the Template profile and the “Clone” button
will appear in the display.
It is only possible to Clone a Profile that was saved
as a Template. Newly cloned Profiles cannot be
cloned.
You will be asked to enter a new transformer name
and then the serial number for the newly cloned
Profile.
Enter the Transformer Name and then the Serial
Number, then touch “Close” to save the Profile.
After entering this information, you have a new Profile to work with.
It's useful to use this sequence of cloning when there are numerous transformers of the same type.
To Next Page
Loading...
