Raytheon ST60 - Boat show mode; Factory defaults; Leaving Dealer calibration

Chapter 4: Calibration 41
Boat show mode
CAUTION:
Do NOT enable this mode. It must only be used for demonstration
purposes.
Ensure that the Boatshow Mode Use is set to OFF. If necessary, use the
trip trip
trip trip
trip or
reset reset
reset reset
reset key to achieve this.
Factory defaults
You can use this screen to reset the operating parameters to the factory
default values. If you want to apply the factory defaults, ensure the
display shows YES, but if you want to retain the values you have set up,
ensure that the display shows NO. Use the
trip trip
trip trip
trip and
reset reset
reset reset
reset keys to
make the required selection.
The values you have selected will be applied when you exit this screen.
Leaving Dealer calibration
Hold down the depth and speed keys for 2 seconds to save your
settings, exit Dealer calibration and resume normal operation.
040_2c04.p65 09/08/99, 09:3241