36 ST6000 Plus Autopilot Control Unit Owner,s Handbook
Mode Bar
Standby Not used
Auto Heading error bar
Track XTE bar
Vane Wind angle error bar
Rudder calibration (DOCKSIDE RUDD CAL)
The Dockside Rudder Calibration function performs an automatic
calibration of the rudder range, for systems with a rudder reference unit.
If a rudder reference unit is not installed, the function determines the
helm drive speed.
WARNING:
This procedure moves the helm, and should only be used when the
vessel is at the dockside. For sterndrive systems, the engines must
running before you start the procedure.
The auto dockside procedure is not available if the ST6000 Plus is used
with a Type 100/300 Course Computer.
If you start the procedure by mistake, press any key to cancel it.
Data pages (DATA PAGE)
The next 7 pages of User Setup allow you change the default settings
for the Data Pages. These are the pages of SeaTalk or NMEA data
available for display using the disp key during normal operation (see
section 2.5).
Each of the setup pages initially shows the title DATA PAGE. After
1second, this changes to show the title of the data currently set for that
page.
The available pages are as follows:
To Next Page
Loading...
