RBH Access Technologies UNC100 Hardware Manual

UNC100 Hardware Manual V1.4 RBH Access Technologies Inc.
Page 29 of 36
Extended use of OSDP Channel
At present, the reader is connected to the respective controller viz RC-2, NURC2000, NIRC2000 etc.
With the OSDP extension, it is possible to use the OSDP readers to
 Read cards
 Buzzer & Led indications as per the access control decisions made
Controllers in this case will only use their respective input & output infrastructure for access control, all the
indications & raw card data read are done at OSDP readers. OSDP can control up to 8 readers (Assuming
max 4-RC DNET).
Since only UNC-500 platform as multi-channel RS-485, Extended OSDP can be used on this platform only.
Configuration
Two readers are associated with every reader controller. The OSDP index is based on the readers DNET
address. See the table below
DNET
Address
Access
point
OSDP
Address
1
A
1
B
2
2
A
3
B
4
3
A
5
B
6
4
A
7
B
8

RBH Access Technologies UNC100 Specifications

General

Brand	RBH Access Technologies
Model	UNC100
Category	IP Access Controllers
Language	English