Using Your TV and Remote
With a Laserdisc Player: Programming and Basic Operation
Refer to your Laserdisc Player owner's manual to hook up your Laserdisc_Player.
The remote may need to be programmed for your laserdisc player. Use the
codes below or on the sheet packed in With your remote.
Programthe remote for
your Laserdisc Player
Basic Operation
PIP SWAP-
A. Point the remote at the laserdisc
playe_ and.hold LD.
B. Enter the code for your brahd -"
from the code list below.
C. Release LD.
D. Press POWER. If nothing
happens, try pressing LD and
then POWER.
A. Tune TV to channel 00, 03, or04.
B. Point the remote at the laserdisc
player and press:I.D.
C. PressPOWER to turn it on. "
D.Use the buttons onthe remote
that relate to laserdisc player
functions. Not all buttons high-
lighted may work with your
laserdisc player.
E. Press POWER to turn it off.
Laserdisc Player Codes
J Pioneer.......................33
ProScan......................33
RCA ................... ........33
t
14
To Next Page
Loading...
