References
Trouble Checks
You may have problems that can be fixed with a few minor adjust, ents.
Look for the type of problem you are having below and then try the
suggestions to get your TV going again. For warranty information see page 32.
Trouble Checks and Adjustments
Power
TV will not turn on
No picture, no sound but
TV has power
Ficture
Blank screen or Unusable
Signa! appears on screen
Hug TV
Plug something else into the outlet to make sure it is working.
Make sure batteries in the remote are not dead.
Aim the remote at the TV and press TV. "
Malce sure baReries amplaced in the remote the right way. See batteries
on page 2.
Unplug TV for a few minutes and then turn it on again.
Check antem_a connections.
Check position of.Cable/Air feature. S_ page 27.
Tryanother channel. Inactive channel may be tuned.
Make sure component connected to the VIDEO INPU T jacks is turned on
ifyou choosechannel00.
Make sure TV is.tuned to the same channel as the switch on back of VCR
ifwatching a VCR.
Make sure TV/VCR button OnVCR is in con_-t position when using VCIL
Try anotherchannel.
Scan,the channels.
Picture poor, sound okay
Check antennaconnectior_
Adjust 'IV picture. Seepages 16-17.
Pi re-in-Picture
Can't get two different
Channels in'picture-in-picture
No picturewhileusing
.picture-in-picturewith
S-VHS VCR orcamcorder
Make suresmallpictureistuned tochannel00.
Make surethecomponent conned:tedtotheback oftheTV isturnedon.
Make sure a video cable is also connected to the TV's VIDEO INPUT jack
if using an S-VI_ component.
Make sure the AUDIO and VIDEO OUT jacks on the VCR, Laserdisc
player, or Camcorder are connected to the TV's VIDEO and AUDIO IN
jacks.
Make sure VCR 1 Channel is set to Disabled. See page 9.
/
Make sure a video cable is also connected to the TV's VIDEO INPUT jack.
3O
To Next Page
Loading...
