References
Trouble Checks
Trouble
Remote
Buttons don't work when you
'pressthem
Checks and Adjustments
Press "iV to set the remote tO control the TV. See buttons on page 6-7.
Works part ornone of the
time
Can't select certainchannei
Sound
Noisystereoreception
Picture okay, no sound
Picture okay, sound poor
No stereo on stereostation
TV Turns on or off
Turns off by itself
Turns on by itself
Does not turn off at
Alarm Time
Clear the path .between the remote and "IV of any objects.
Aim the/emote at the component you are trying to control
Press TV so remote will control TV.
Make sure batteries in the remote are not dead.
See ifbatteries are placed in remote correctly: See batteries, page 2.
Press number buttons. Channel may not be in memory. See autoprogram
on page 20.
Make sure TV/VCR switch on VCR is in the TV position.
For numbers over 100, press and hold I until 1- appears, then press the
other two numbers.
Set Cable/Air feature to Cable for channels higher than 69. See page 27.
Turn Stereo off. The stereo broadcast may not be dear. See page 18.
PressVOLUME + orMUTE to restore sound.
Make sure TV's speakers are on. Details are on page 19.
Try another channel.
Try adjusting the Tone. Seepage 18.
Change Stereo to off. The stereo broadcast may not be dear. Seepage 18.
Make sure Stereo is turned on. Seepage18.
Check Sleep Timer. See sleep timer on page 22.
Wait 30 seconds and turn on again, a power surge may have occured.
Check Alarm Off time. See alarm clock on page 23.
Check Aiarm On Time. See alarm clock on page 23.
Check dock Fune. See clock on page 3.
\ •
Make sure alarm is turned on or off. See alarmdock on page 23.
Check clock time. See clock on page 3.
31
To Next Page
Loading...
