RCA VR344 - Auto Channel Search

2. Press 4 to display the CHANNELS menu.
CHANNELS
1 AUTO CHANNEL SEARCH
2 ADD/REMOVE CHANNELS
3 SIGNAL TYPE:
CABLE
4 VCR PLUS+ CHANNEL LIST
5 CABLE BOX SETUP
0 EXIT
3.
Press 1 to display the AUTO CHANNEL SEARCH menu.
AUTO CHANNEL SEARCH
WHAT TYPE OF SIGNAL
ARE YOU USING?
1 CABLE TV
2 ANTENNA
3>DETECT AUTONATICALLY
0 CANCEL
4.
Select one of the three AUTO CHANNEL SEARCH options.
Choices one and two are self-explanatory. If you choose
DETECT AUTOMATICALLY, the VCR automatically detects
which signal system you have attached to your VCR.
AUTO CHANNEL SEARCH
NOW SCANNING CHANNEL 14
PRESS ANY KEY TO CANCEL
The VCR begins scanning for the available channels--this
takes about one to two minutes. The lowest channel is tuned
once the search is complete. Now pressing CHANNEL up or
down should only select the active channels.
.
Detect Automatically
A strong cable or antenna signal in
your area may cause Auto Detect
to mis-detect. If this should
happen, select 1 or 2 for the
system you have.
l
Auto Channel Search
Use the AUTO CHANNEL SEARCH
feature to place all available
channels in memory.
If you ever change cable or
antenna signals, you may need to
AUTO CHANNEL SEARCH again.
11