43 | P a g e
TEACHING RF CODE – Reprogramming remote to heater
1. Electrical tray must be slid forward to reprogram a remote control.
2. Turn the remote to off mode
3. Turn mains power to heater on.
4. Press the red button on the receiver once – three beeps should be heard.
5. Press the on button on the remote – four beeps should be heard.
6. Remote is now connected.
If your fireplace still does not operate correctly consult your dealer, installer or gas service technician.
All service and repairs should be performed by an authorised agency
All spare parts are available from Glen Dimplex Australia Pty Ltd.
FAULT CODES
Gas Valve controller – no
fault codes available.
Remote – no faults codes
available.
To Next Page
Loading...
