PRESSURE ALTERNATING MODE - the mattress cells are
alternately inflated and deflated. The three cells in the head section
are constantly filled with air. The pump runs in pressure mode for a
fixed time cycle until a different mode is selected.
CLP (CONSTANT LOW PRESSURE) MODE - the pressure inside
the mattress remains at a constant set level reduced by 50%
compared to the set. The pump runs in CLP mode continuously until
another mode is selected.
STATIC MODE - the pressure inside the mattress remains
constant. 30 minutes after entering this mode, the pump will
automatically switch to the pressure mode.
It protects the system against any accidental changes of settings. It
turns on automatically 30 seconds after the last changes are made
or can be started by the user by pressing the button.
To unlock the panel, press and hold the lock button for about 3
seconds.
The pressure inside the mattress is selected automatically depending
on the weight and position of the patient or set manually by the user.
Auto Set - automatic
pressure adjustment
Manual pressure adjustment
To start the automatic pressure selection for the patient's weight
and position, press the and buttons simultaneously.
The Auto Set LED diode will start flashing, which means that the
automatic pressure selection process inside the mattress has
started. At the end of the process, a short beep will sound and the
LED diode will change to steady. The pressure selection process will
be repeated periodically. The mattress will work in Auto Set mode
until it’ll be switched to the manual adjustment mode.
Pressing the or button when the pump is set to
automatic pressure selection (Auto Set) will disable this function and
go to manual pressure regulation inside the mattress, which will be
indicated by the Auto Set diode going off. To set the desired pressure
level according to the patient's weight manually, press the
To Next Page
