Real MULTIDEC MD090-1301BTR - Emc Information

28
19. EMC INFORMATION
WARNING – Use of this equipment adjacent to or stacked with other equipment should be avoided
because it could result in improper operation. If such use is necessary, this equipment and the other
equipment should be observed to verify that they are operating normally.
WARNING – Use of accessories, transducers, and cables other than those specified or provided by the
manufacturer of this equipment could result in increased electromagnetic emissions or decreased
electromagnetic immunity of this equipment and result in improper operation.
Description
Cable Length
Power Cable (non-shielding)
5m
WARNING – Portable RF communications equipment (including peripherals such as
antenna cables and external antennas) should be used no closer than 30 cm (12
inches) to any part of this device, including cables specified by the manufacturer.
Otherwise, degradation of the performance of this equipment could result.
Manufacturer’s declaration-electromagnetic emissions
The device(s) is intended for use in the electromagnetic environment (for home and professional
healthcare) specified below.
The customer or the user of the device(s) should assure that it is used in such an environment.
Emission test
Compliance
Electromagnetic environment-guidance
(for home and professional healthcare environment)
RF emissions CISPR
11
Group 1
The device(s) uses RF energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby
electronic equipment.
RF emissions CISPR
11
Class B
The device(s) is suitable for use in all establishments,
including domestic establishments and those directly
connected to the public low-voltage power supply
network that supplies buildings used for domestic
purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations
/flicker emissions IEC
61000-3-3
Compliance