Real MULTIDEC MD090-1301BTR - Alarm Codes

23
3. CHANGING THE AIR FILTER
• The air filter is located on the rear housing of the pump
• The filter is reusable and can be gently cleaned by dipping in a mild
detergent solution
• Before reinstalling the filter, make sure it is thoroughly dried
• The filter should be checked regularly and replaced if it becomes dirty
TECHNICAL INSPECTIONS
To maintain the mattress and pump in good condition, the manufacturer recommends that periodic
technical inspections are carried out every 24 months.
16. ALARM CODES
A. Table – alarm codes
Priority
High
↓
Low
Warning
code
LED Indicator
Acoustic signal
Warning
Notes
0
not
applicable
not applicable
One-time
Acoustic signal
Beep of
functional
button
1
S.d.
No power
supply
One-time
Shutdown
action
Turning off
2
8.8.
All LEDs
One-time
Starting up
All indicators
are on
3
not
applicable
not applicable
One-time
Status / mode
switch
Display off
4
I.E.
Full inflation
mode mode
One-time
Completion of
initial inflation
Initial inflation
completed
5
A.E.
Full inflation
mode mode
One-time
Maximum filling
achieved
The end of the
maximum filling
of the mattress
6
S.E.
The static mode
One-time
Ending static
mode
End of work in
static mode
7
not
applicable
No power
supply
Cyclic (every 4
seconds)
Power failure
alarm
Display off