2. Uploading Modes
The scanner can operate in one of two uploading modes.
2.1 Instant Upload Mode
After scanning label , the decoded barcode will be instantly uploaded
to where the cursor is. The buzzer beeps “ di “ when the scanner
successfully read and upload the decoded barcode.
2.2 Storage Mode
In storage mode, all decoded barcodes will stored in the memory
of the scanner and will not be uploaded to the Host instantly. You
can batch upload all decoded barcode by scanning the setting
code”Upload data “
An operation in storage mode is strongly recommended under the
following scenarios:
1) During the scanning process, the device often leaves the
Bluetooth / wireless signal range;
2) Due to a high quantity of blocking objects, the Bluetooth / wireless
signal’s stability can’t be ensured.
** To batch upload all decoded barcodes, scan setting code”Upload
Barcodes “
To Next Page
Loading...
