14
4. Machine Assembly
Fig.4.6
TRUNNION
TABLE FIXING BOLT & WASHER
4.2 Rise & fall hand wheel
Attach the rise and fall hand wheel to the rise and fall shaft and tighten
the socket head bolt with a 6 mm hex wrench, then attach the handle and
tighten with a 10 mm wrench (See Fig.4.2).
4.3 Belt tension handle
Attach small crank handle to belt tension and speed mechanism with
10 mm wrench (not supplied) (See Fig.4.3).
4.4 Fitting the table
Tools Required: - 13 mm wrench (not supplied)
Remove the hex socket screws and keep plate from beneath the table as
shown in Fig. 4.4 to allow the blade to pass into the table's blade slot.
Once the table is secured to the machine, refit the keep plate.
With the help of another person, lift the working table onto the trunnion.
Mount the working table on the trunnion using the supplied 4 x table
fixing bolts and 4 x washers (See Fig.4.5 front view & 4.6 rear view).
4.5 Fitting the tension knob
To fit the tension knob, slot it into the keyway on the top of the bandsaw.
Fig.4.7.
Fig.4.3
BELT TENSION & SPEED CHANGE
Fig.4.2
RISE & FALL
Fig.4.7
Fig.4.5
TRUNNION
TABLE FIXING BOLT & WASHER
KEEP PLATE
HEX SCREW
Fig. 4.4
To Next Page
Loading...
