EasyManua.ls Logo

red lion T48 - Page 6

red lion T48
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AlarmActionFigures··························································· 40
AlarmReset(rSt1,rSt2)························································ 42
Alarm Standby Delay (Stb1, Stb2) ················································ 42
AlarmValue(AL-1,AL-2)······················································· 42
AlarmHysteresis(AHYS)······················································· 42
Cooling Parameters Module (5-02) (Optional) ········································· 43
CoolingOutputCycleTime(CYC2)··············································· 43
CoolingRelativeGain(GAn2) ··················································· 43
Heat and Cool Overlap/Deadband (db-2) ·········································· 43
Serial Communications Module (6-SC) (Optional) ······································ 44
BaudRate(bAUd)····························································· 44
CharacterFrameFormat(ConF)················································· 44
ControllerAddressNumber(Addr) ··············································· 44
AbbreviatedorFullTransmission(Abrv)··········································· 44
PrintOptions(PoPt) ··························································· 44
Remote Setpoint Parameters Module (7-n2 or 7-rS) (Optional) ···························· 45
RemoteSetpointDisplayValues(dSP1anddSP2)·································· 45
Remote Setpoint Signal Input Values (INP1 and INP2) ······························· 45
RemoteSetpointFiltering(FltrandbANd) ········································· 45
Remote/LocalSetpointTransferOptions(trnF) ····································· 45
Heater Current Monitor Module (7-N2 or 7-HC) (Optional) ······························· 46
Second Linear DC Analog Output Module (8-A2) (Optional) ······························ 46
Second Linear DC Output Range (A2tP) ··········································· 46
Second Linear DC Output Scaling Points (A2LO, A2Hl) ······························ 46
Factory Service Operations Module (9-FS)············································ 46
MANUALCONTROL ································································ 47
ON/OFFCONTROL································································· 48
AUTO-TUNEFORPIDCONTROL····················································· 51
InitiateAuto-Tune································································ 52
Auto-TuneOfHeat/CoolSystems··················································· 52
Auto-TuneOfCascadeControl ····················································· 52
PID CONTROL EXPLANATIONS ······················································ 53
Proportional Band ································································ 53
IntegralTime···································································· 53
-iv-

Table of Contents

Related product manuals