red lion T48 - Module 3: Lockout Parameters (3-LC); Lockouts Parameter Module (3-LC)

Configure Module 3 - Lockout Parameters (3-LC)
Display Parameter
Range and Units
(Factory Setting)
Description/ Comments
SP Setpoint access LOC - lockout
rED - read only
Ent - enter
(Ent)
Determines access to
temperature setpoint.
OP Output power
access
LOC - lockout
rED - read only
Ent - enter
(Ent)
Determines direct
access to output power.
%P indicator illuminates
when parameter is
selected in display.
dEv Deviation display
access
LOC - lockout
rEd - read only
(rEd)
Determines display of
deviation. DV indicator
illuminates when
parameter is selected in
display. (Does not
appear if heater current
option is installed).
Hcur Heater current
display access *
T48 only
LOC - Lockout
rEd - read only
(rEd)
Determines heater
current readout. DV
indicator Illuminates
when selected.
UdSP Units display
access
For T48
LOC - lockout
rEd - read only
(rEd)
Determines display of F
or C.
bdSP Blank display
access
For P48
LOC - lockout
rEd - read only
(rEd)
Determines blank
secondary display.
CodE Access code 0 to 250
(0)
Refer to front panel
disable section for
access levels.
Display Parameter
Range and Units
(Factory Setting)
Description/ Comments
PId PID values
access
LOC - lockout
rEd - read only
Ent - enter
(LOC)
Protected Mode lockout.
AL Alarm values
enable *
LOC - lockout
rEd - read only
Ent - enter
(LOC)
Protected Mode lockout.
ALrS Reset alarms
enable *
LOC - lockout
ENBL - enable
(LOC)
Hidden Mode lockout.
SPSL SP1/SP2/Remote
setpoint enable *
LOC- lockout
ENBL - enable
(LOC)
Hidden Mode lockout.
trnF Automatic/Manual
(user) mode
select enable
LOC - lockout
ENBL - enable
(LOC)
Hidden Mode lockout.
tUNE Auto-tune enable LOC- lockout
ENBL - enable
(LOC)
Hidden Mode lockout.
* Model Number Dependent
-24-