22
Red Sea MAX
Power center
1. Ensure that your hands are dry.
2. Remove the power center splash cover by sliding it away
from the power cord and lifting. Familiarize yourself with how
the splash cover locks into position.
3. Hold the power center near to the power center housing at
the rear of the Max. Connect the cables from the various
components to the power center in the following order,
placing the plugs in the matching sockets:
4. Plug the circulation pumps into sockets #4 and #5.
5. Plug the heater into socket #3.
6. Plug the skimmer pump into socket #2.
7. Plug the hood cord into socket #1.
8. Gather the component cables together and replace the
splash cover.
9. Hold the power center with the cable at the bottom. Insert
the power center power cord into the cable niche at the
bottom of the back wall. Insert the power center, into the
power center housing. Use the lip at the bottom to position
the box properly. (fig 31) and push until the power center
snaps into position at the top.
Figure 29: Removing the splash cover
Figure 30: Power center
To Next Page
Loading...
Need help?
General
