3. If using an eSATA connection, power the RED STATION RED MINI-MAG – ESATA/USB 3.0 with one of the
following cables:
RED STATION AC Power Adaptor
RED STATION USB to DC Power Cable (24")
4.
Set the On/Off Switch on the back of the RED STATION RED MINI-MAG – ESATA/USB 3.0 to On.
5. Install the RED MINI-MAG in the media slot on the front panel of the RED STATION RED MINI-MAG – ESATA/USB
3.0.
The computer recognizes the inserted RED MINI-MAG and displays the RED MINI-MAG as a new drive.
NOTE: To offload data from the SSD, go to "Offload Data From Media to Your Computer" on page56.
RED STATION RED MINI-MAG – USB 3.1
This section explains how to connect a RED MINI-MAG to your computer using a RED STATION RED MINI-MAG –
USB 3.1.
1. Place a RED STATION RED MINI-MAG – USB 3.1 on a firm, flat surface.
2. Connect the RED STATION RED MINI-MAG – USB 3.1 to a computer using one of the following cables:
RED STATION USB-C to USB-C CABLE – USB 3.1 (24")
RED STATION USB-C to USB-A CABLE – USB 3.1 (24")
3. Install the RED MINI-MAG in the media slot on the front panel of the RED STATION RED MINI-MAG – USB 3.1.
The computer recognizes the inserted RED MINI-MAG and displays the RED MINI-MAG as a new drive.
NOTE: To offload data from the SSD, go to "Offload Data From Media to Your Computer" on page56.
CONNECT A REDMAG 1.8" SSD TO YOUR COMPUTER
This section explains how to connect a REDMAG 1.8" SSD to your computer using the following RED STATIONs:
RED STATION REDMAG 1.8"
RED STATION REDMAG 1.8"
(Mini)–eSATA RED STATION REDMAG 1.8"
(Mini)–USB 3.0 RED STATION REDMAG 2.5"
NOTE: You can daisy-chain most FireWire storage devices, including RED STATION RED MINI-MAG – ESATA/USB
3.0s and RED STATIONs (for REDMAG 1.8" SSDs).
C O PYRIGHT © 2 017 R ED.C OM , LLC 955- 0047, REV- AH| 53
RED DSMC MEDIA OPERATION GUIDE
To Next Page
Loading...
