RED scarlet - Page 54

To Next Page

To Previous Page

SET UP RED STATIONS WITH A RED STATION BASE

NOTE: The RED STATION Base provides power to up to three (3) RED STATIONs (excluding the RED STATION

REDMAG 1.8" (Mini) and RED STATION RED MINI-MAG – ESATA/USB 3.0) using the RED STATION DC Power

Coupler (2") that’s included with the RED STATION Base.

1. Place the RED STATION Base on a firm, flat surface.

2. Place up to three (3) of the following RED STATIONs on top of the RED STATION Base, aligning the four (4)

bottom pegs with the four (4) rubber pads on top of the RED STATION Base:

RED STATION REDMAG 1.8"

RED STATION REDMAG 2.5"

3. Firmly press down on each RED STATION to insert the pegs into the rubber pads, creating one stacked unit.

4. Plug the RED STATION DC Power Coupler (2") into the POWER connector on the RED STATION Base and one

POWER connector of the RED STATION directly on top of the RED STATION Base.

5. Use RED STATION DC Power Couplers (2") to daisy-chain any remaining RED STATIONs by plugging the cables

into one POWER connector on each RED STATION.

6. Connect the RED STATION to a computer using one of the following data connectors:

WARNING: DO NOT connect more than one (1) data cable between one (1) RED STATION and the computer.

CONNECTOR CABLE (INCLUDED WITH

RED STATION)

NOTES

eSata RED STATION eSATA Cable

(24")

After connecting via eSATA, it may take up to 15 seconds for

the media to display on the computer.

FireWire 800 RED STATION FW800

Cable (2")

RED STATION FW800

Cable (24")

You can use the 2" FireWire 800 cables (included with each

RED STATION) to daisy-chain the RED STATIONs. Then, use

one (1) FireWire 800 cable to connect one (1) RED STATION to

the computer. The computer then recognizes each RED

STATION through a single FireWire connection.

MINI USB USB-to-MINI USB Cable (24") N/A

7.

Set the On/Off Switch on the back of each RED STATION and the RED STATION Base to On.

NOTE: When the On/Of Switch on the RED STATION is set to on, the On/Of Switch on the RED STATION Base

turns the RED STATION on/off.

8. Install the REDMAG 1.8" SSD in the media slot on the front panel of the RED STATION.

The computer recognizes the inserted SSD media and displays each SSD as a new drive.

NOTE: To offload data from the SSD, go to "Offload Data From Media to Your Computer" on page56.

RED DSMC MEDIA OPERATION GUIDE

Other manuals for RED scarlet