RED scarlet - Page 55

SET UP A STAND-ALONE RED STATION (WITHOUT RED STATION
BASE)
This section explains how to connect a REDMAG 1.8" SSD to your computer using one of the following without a RED
STATION Base:
RED STATION REDMAG 1.8"
RED STATION REDMAG 1.8"
(Mini)–eSATA RED STATION REDMAG 1.8"
(Mini)–USB 3.0 RED STATION REDMAG 2.5"
To offload media, follow the instructions below:
1. Place RED STATION on a firm, flat surface.
2. Connect the RED STATION to a computer using one of the following data connectors:
WARNING: DO NOT connect more than one (1) data cable between one (1) RED STATION and the computer.
CONNECTOR CABLE (INCLUDED WITH RED
STATION)
NOTES
eSATA RED STATION eSATA Cable (24") After connecting via eSATA, it may take up to 15
seconds for the media to display on the
computer.
FireWire 800 RED STATION FW800 Cable (2")
RED STATION FW800 Cable (24")
The computer supplies power to the RED
STATION via the FireWire 800 connection, so
it’s not necessary to use the RED STATION
AC Power Adaptor. But for optimal
performance, use the power adaptor.
You can use the 2" FireWire 800 cables
(included with each RED STATION) to daisy-
chain the RED STATIONs. Then, use one (1)
FireWire 800 cable to connect one (1) RED
STATION to the computer. The computer then
recognizes each RED STATION through a
single FireWire connection.
MINIUSB USB-to-MINI USB Cable (24") If connecting to the computer using a different
MINI USB cable than provided, power the RED
STATION with the RED STATION AC Power
Adaptor.
USB 3.0 (RED
STATION
REDMAG 1.8"
(Mini) only )
RED STATION USB 3.0 Cable (24") If connecting to the computer using a different
MINI USB cable than provided, power the RED
STATION with the RED STATION AC Power
Adaptor.
3. If using an eSATA connection, power the RED STATION with either of the following cables:
RED STATION AC Power Adaptor
RED STATION USB to DC Power Cable (24")
C O PYRIGHT © 2 017 R ED.C OM , LLC 955- 0047, REV- AH| 55
RED DSMC MEDIA OPERATION GUIDE