Before every instance of use, check the Verti-Drain
®
for loose
bolts/nuts/components.
If applicable, regularly check the hydraulic tubes and replace them if damaged or
when showing signs of wear and tear. The replacement tubes must comply with
the technical requirements of the manufacturer.
If applicable, pressure in the hydraulic installation should always be released
before any work is carried out on it.
If the protective covers and safety stickers are absent, the Verti-Drain
®
should
NEVER be used.
Do NOT crawl underneath the Verti-Drain
®
.
If necessary, tilt the Verti-Drain
®
up.
Do NOT get off the tractor if the engine is still running.
During maintenance and repairs, it is necessary to secure and block the Verti-
Drain
®
in order to prevent it from sagging/moving/sliding.
During maintenance, adjustments and repairs always turn off the tractor engine and
remove the tractor key from the ignition and decouple the PTO. (Fig. 2)
Fig. 2
For the safety of the machine and the operator, only use original Verti-Drain
®
components for maintenance or repair.
Repair activities on the Verti-Drain
®
may exclusively be done by authorized
technical personnel.
Keep an overview of repairs.
(5) Besides the instructions in this manual, the general applicable health, safety and
welfare regulations have to be complied with.
When using on public roads, the related traffic regulations are also applicable.
Transportation of persons is not permitted!
Do not use the Verti-Drain
®
in the dark, during heavy rainfall/storms, or on slopes with
an inclination over 20 degrees.
To Next Page
Loading...
