Setting Event Blocking (defeat siren / voice)
1. Press and hold PROG key for 2 seconds to enter program
menu page. Skip this step if it is now in program menu.
2. Keep pressing key to menu page P6.
3. Press ENTER key to select.
4. Press key to scroll through the alert messages to edit.
7. Press ENTER key to confirm.
8. Repeat steps 4 to 7 to edit others if you desire.
Alert Disable (flashing) = Event Blocked
Alert Enable (flashing) = Event Not Blocked
5. Press ENTER key to select the message to be edited.
6. Press key to set it to block or not.
The Event No., Corresponding to the Alert Message
Table, is displayed on the LCD.
Some alert messages can be set to no audio alert (SIREN
and VOICE) but display the messages on the LCD in
order not to annoy you frequently.
These messages are grouped from Event No. 1 to 48 in
the Alert Message Table. When the radio receives such a
message e.g. REQUIRED WEEKLY TEST, and you have
already set it blocked, there will be no siren nor voice
alert but display the message on the LCD.
The ALARM OUT socket will not be activated if the
blocked event is received.
The messages below are initially set to block
at the factory (by default).
1. REQUIRED WEEKLY TEST
2. REQUIRED MONTHLY TEST
3. ADMINISTRATIVE MESSAGE
4. NATIONAL INFORMATION CENTER
5. NATIONAL PERIODIC TEST
6. NATIONAL AUDIBLE TEST
7. NATIONAL SILENT TEST
8. NETWORK NOTIFICATION MESSAGE
9. PRACTICE / DEMO
Editing Event Blocking
Press PROG key to end this section.
- 15 -
Info
Note
Hint
Note
Hint
To Next Page
Loading...