Getting Started
Choosing A Location
Powering Up the Radio
Installing the Back-up Batteries
1. Press down the battery base cover and slide it downward
to remove.
2. Insert four batteries with the correct polarity as indicated
by the '+' and '-' symbols inside the component.
3. Place the battery case cover back on the radio by sliding
it upwards until it clicks into place.
The radio requires four (4) 1.5 Volt AA size batteries
for back-up power when AC power fails (especially
during emergency) or is temporarily disconnected.
1. When the back-up battery is low, the LCD will
display icon.
2. It is recommended to always power up the radio
with the supplied AC adapter to maximize back
up battery life time.
3. Do not leave weak or dead batteries in the battery
compartment; the batteries may leak and damage
the radio.
Connect the supplied AC adapter to the radio's DC Jack
and to a standard 120V AC wall outlet.
- Choose a location nearing a window that is facing the
direction the NOAA (National Oceanic and Atmospheric
Administration) broadcast is coming from.
- Keep the radio away from obstructions such as a
refrigerator, a metal door, cabinet or wall, or a water pipe
hidden behind a wall which would greatly reduces the
radio's reception sensitivity.
- keep the radio away from sources of electrical noise such
as motors, microwave ovens, and fluorescent lighting.
- The location should be close to a continuous power outlet
which is not switchable.
- 5 -
Info
Note
To Next Page
Loading...