- 21 -
Operation
Review Alert Message
- Press MEMORY key (in standby mode) to enter event
memory mode.
LCD Back Light
If the radio is powered up by AC adapter, press ENTER key to
turn on / off LCD back light (toggle key function).
If the radio is powered up by back up battery, press any key once
will turn on the LCD back light for 10 seconds.
If the radio has not received any alert message ever
since the radio powered up, the LCD will display:
'NO EVENT MESSAGES'.
Press MEMORY key again, you will see the date / time
stamp for the alert message at the time received. The
message number is shown on the bottom right at this
time.
Access to Program Menu Page
- Press and hold PROG key for 2seconds.(in standby mode)
Review Stored County Codes
- Press or key (in standby mode) to see the county code(s).
If alerts have been received before, you will see the alert
message and the message number on the display. The
highest message number is for the latest alert message.
The effective time will be shown if the alert
event is still in effect. The 'Effective Time OFF', if
shown, indicates the event effective time count down has
expired but the emergency event may still continue.
The radio's memory can store up to 25 alert messages. If
the memory is full and if a new message receives, the
oldest message will be cleared and the new message will
be saved to the memory.
You must set the real time clock and date correctly to
ensure the message receiving time in event memory is
properly displayed.
Standby Mode : When the radio is ready for use, no
voice on the speaker, and you have not pressed any
key, the radio is in standby mode.
Info
Info
Tips
Note
To Next Page
Loading...