5. Press ENTER key to confirm.
The radio initially sets to the ALL COUNTY CODES by
default. With this option, the radio will respond to all
alerts regardless of the affected areas as long as the
channel is correctly set.
If you want to monitor alerts in more than one county
(area), the MULTIPLE COUNTY option would be the
choice. You can store up to 26 county codes in the radio
memory. The more the county codes you store in, the
broader the area coverage the radio will monitor and
vice versa.
If the SINGLE COUNTY option is selected, the radio
will monitor alerts only affecting your local county /
area. You must store the county code in the first memory
location which is COUNTY 01.
If the ALL COUNTY CODES option is selected,
this section is completed.
If there is no county codes stored in the memory, go
to next step.
6. Press or key to scroll memory locations for county
code entry / edit.
7. Press ENTER key to select.
8. Press or key to input the desired code number.
9. Press key to the next digit.
10. Repeat steps 8 & 9 to input the 2nd to 6th digit.
11. Press ENTER key to save.
Press and hold or key will continuously
change the number. Release the key to stop.
Repeat steps 6 to 10 to enter the next county code, if any.
If any one of the code digit is blank ( _ ), the input
will not be updated.
If there is no county codes stored in the memory, the
radio will re-set to ALL COUNTY CODES option
automatically.
Press PROG key to leave this section.
- 8 -
Info
Hint
Hint
Tips
Hint
Note
To Next Page
Loading...