35
• Always leave the remote control (transmitter) switched on when the model is in use. After landing, always
switchoffthehelicopterrstbeforeyouswitchofftheremotecontrol.
• Never switch the remote control off when the helicopter is switched on.
• Do not expose the model or the remote control to direct sunlight or excessive heat for prolonged periods.
• In the event of a severe crash (e.g. from a high altitude), the electronic gyro sensors may be damaged.
Alwayscheckthatthemodelisfunctioningproperlybeforeyingitagain!
• If the rotors are blocked by obstacles, switch off the rotor motors immediately. Blocked motors have an
increased power consumption, which can destroy the motors and the motor controller.
• Rotating rotors can be damaged by contact with obstacles. Check the rotors for any signs of cracks or
damagebeforeyingthemodelagain!
• To avoid damaging the model due to a crash caused by an low voltage/total discharge of the recharge-
ablebattery,monitorthelowvoltageindicatorsduringtheight.