Reer Mosaic Series - Module MBEC; Module MBEI

Mosaic fieldbus modules
8540467 • 04/10/2018 • Rev.0 12
The "Diagnostic code" field
"Diagnostic code"
Input diagnostics
CODE
NAME
MEANING
128
Input diagnostics OK
1
Not passed from zero
Both contacts have not returned to their rest position
2
Simultaneous control failed
The two contacts of a generic two-channel input do not close
simultaneously
3
Two hands Simultaneity failed hand 1
Incorrect connection of one side of a two-hand command
4
Two hands Simultaneity failed hand 2
Incorrect connection of one side of a two-hand command
7
Incoherent selector
The selector cannot have more than one active input
8
Disconnected selector
The selector cannot have any active input
10
OUT_TEST error
Presence of diagnostics on an OUT_TEST connected to the input
11
Second input KO
Redundancy check failed on entry
13
Output connected to other inputs
The test output is not connected to the configured input
14
Output OK but input connected to 24DC
Input blocked
15
Short circuit between photocell test and
photocell input
The response time of the photocell is too low
16
Photocell does not respond
Test signal on the emitter is not present on the photocell receiver
17
Short circuit between photocells
Test signal is present on two different photocells
18
Safety carpet not connected
One of the two carpet connections is not correct
19
Output not congruent to feedback
Test signal applied to the input is present on more than one OUT_TEST
20
Wrong connection
Test signal is present on more than one input
21
Stucked output
Test signal applied to the input is not present on the OUT_TEST
22
Second OUT_TEST KO
Redundancy check failed on OUT_TEST
23
MVx Proxy resource missing
24
MVx Encoder resource missing
25
MVx Resource proxy encoder missing
26
MVx Resource proxy1 proxy2 missing
27
MVx Resource encoder1 encoder2 missing
28
MVx Frequency congruence error
29
MVx Encoder supply missing
30
MVx Encoder fault
40
MA4C Reading out of lower threshold
41
MA4C Disconnected sensor
42
MA4C Reading out of upper threshold
43
MA4C Overload
44
MA4C Mismatch between channels
133
Simultaneity two failed hands
The two contacts of a two-handed control do not close at the same time
134
Never started
Input with failed test at startup
137
Waiting for restart
Reset to an input with manual reset has not been activated
TWO-HAND concurrent failed
Two-hands switch has to change state simultaneously
Not started
Start test failed
Waiting for restart
The input has manual reset and has not been restarted
Table 4