Checking MerCrusier Stern Drive Oil
1. Drive oil level must be checked with the engine cold before starting.
2. Check the gear oil level in the reservoir located on the engine.
Keep the gear oil level at the recommended ranges as marked on
the reservoir. If any water is visible at the bottom of the reservoir
or there are any metal chips in the drive oil do not run the engine
since component damage can result. Contact your Regal dealer for
more information.
Filling the Stern Drive
1. If more than 2 ounces of High Performance
Gear Lubricant is required to fill the
monitor reservoir a seal may be leaking.
Contact your Regal dealer.
2. If drive lubricant is free from water and
metal chips proceed to ll the reservoir.
Remove the gear lube monitor cap. Fill
the reservoir with High Performance Gear
Lubricant (Merc part # 92-802854A1).
A=Drive Reservoir
A
ENVIRONMENTAL HAZARD!
DISCHARGE OF OIL OR OIL WASTE
INTO THE ENVIRONMENT IS RESTRICTED BY LAW.
DO NOT SPILL OIL OR OIL WASTE INTO THE ENVIRON
MENT WHEN USING OR SERVICING YOUR VESSEL.
DISPOSE OF OIL OR OIL WASTE AS DEFINED
BY LOCAL & STATE AUTHORITIES.
To Next Page
Loading...
