7-44
Chapter 7
3. Fill the reservoir so that drive oil level is in the operating range.
Do not over ll reservoir. For changing the drive oil refer to the
MerCruiser operation manual or contact a Regal dealer for more
information.
Checking Power Steering Fluid
1. Stop the engine and center the out drive unit.
2. Remove the combo ll cap/dipstick and observe the level.
a. Proper uid level with engine at normal operating
temperature should be within the warm range.
b. Proper uid level with engine cold should be within cold range.
3. Fill to line with Quicksilver Power Trim & Steering Fluid (Merc
# 92-802880A1) or Dextron III automatic transmission uid. If you
can not see any uid in the power steering reservoir contact your
Regal dealer since a leak must of developed in the system.
a=Power Steering Pump
b=Engine Cold Range
c=Engine Warm Range
To Next Page
Loading...
