Regin Corrigo E series - Chapter 7 Access Rights

Corrigo E Heating manual, revision G Chapter 7 Access rights 24
Chapter 7 Access rights
There are 3 different log on levels, System level which has the highest authority, Operator level and
the basic “no-log on” level. System level gives full read / write access to all settings and parameters
in all menus. Operator level gives read-only access to all settings and parameters and write access to
all settings and parameters in all menus except Configuration. The basic level permits read-only
access to all settings and parameters.
Repeatedly press down-arrow when the start-up display is shown until the arrow-marker to the left
of the text-list points to Access rights. Press right-arrow.
Log on
Log off
Change password
7.1 Log on
Log on
Enter password:****
Actual level:None
In this menu it is possible to log on to any level by entering the appropriate 4-digit code. The log on
menu will also be displayed should you try to gain access to a menu or try to do an operation
requiring higher authority than you have.
Press the OK-button and a cursor marker will appear at the first digit position. Repeatedly press the
up-arrow until the correct digit is displayed. Press the right-arrow to move to the next position.
Repeat the procedure until all four digits are displayed. Then press OK to confirm. After a short
while the text on the line: Present level will change to display the new log on level. Press left-arrow
to leave the menu.
7.2 Log off
Use this menu to log off from the present level to the basic "no-log on" level.
Log off?
No
Actual level:System
Logoff is also initiated automatically 5 minutes after the last time a button is pressed.
7.3 Change password
As default Corrigo comes with the following passwords for the different levels:
System 1111
Operator 3333
Basic 5555
You can only change the password for log on levels lower or equal to the presently active level, i. e.
if you are logged in as System you can change all passwords, but as Operator you can only change
the Operator and Basic passwords. There is no point in changing the Basic password since access to
that level is granted automatically to all users.