Corrigo E Heating manual, revision G Chapter 4 Commissioning 15
Chapter 4 Commissioning
General
Before the Corrigo can be used it must be configured, inputs and outputs must be assigned and all
relevant parameters must be set.
All commissioning can be done using the Corrigo front panel display and buttons or using the
display unit E-DSP.
Corrigo E-tool
The best way however, is to configure the Corrigo E by using Corrigo E-tool.
Corrigo E-tool is a PC-based configuration program specially developed to simplify the
commissioning of the Corrigo E-series.
When using E-tool the whole configuration and all settings can be done on the computer and then
downloaded to the Corrigo. An infinite number of different configurations can be saved in computer
memory for later use.
4.1 How to do it?
For configuration using E-tool, see the E-tool manual.
For configuration using the front panel there are two ways to go depending on how much help you
need.
Option 1:
• Jump straight to chapter 6 and 7, Display, buttons and LEDs and Access rights.
• After mastering the button and menu system, connect power to your Corrigo, log on at
System level and go to the menu Configuration.
• For the time being, skip the configuration menu Inputs/Outputs and start by configuring
Control functions.
• Run through the configuration menus in order and set whatever functions and parameters
you wish to include. Use chapter 4 of this manual for reference. Keep track of which inputs
and outputs you will need. To help you, there is a list of input and output functions
provided in chapter 3, (3.2.3 Input / Output list.)
• Finally, configure Inputs/Outputs.
• Exit Configuration and go to Settings
• Set the control values in Settings
• Set the clock and scheduler functions in Timers.
• Set the control setpoints in Actual/Setpoint.
Your Corrigo should now be ready to run.
Option 2:
Read this manual in the order given below: The manual has been designed to act as a guide through
the commissioning. The last chapters of the manual, not listed below, cover menus and functions
that are not used during commissioning.
To Next Page
Loading...