16
Manual CORRIGO U-SERIE 2002-09
Example of configuration
table
KONFIG. KOD 1
0011.1110.0000
KONFIG. KOD 2
0100.0100.11
KONFIGURERING-CORRIGO U20 A B C D . E F G H . I J K L
Konfigureringskod 1 1 . .
A Function sensor AI1
1. Outdoor sensor (Can not be changed) 1
B Function sensor AI2
0. --- Input not active 0
1. HS1 Supply 1
C Function sensor AI3
0. --- Input not active 0
1. HS1 Room sensor 1
2. HWC Return 2
D Function sensor AI4
0. --- Input not active 0
1. HS1 Return 1
2. HP Supply 2
E Function sensor AI5
0. --- Input not active 0
1. HW Supply 1
2. HP Return 2
F Function sensor AI6
0. --- Input not active 0
1. THW Supply 1
G Function sensor AI7 (C20 only)
0. --- Ingången ej aktiv 0
1. HS2 Supply 1
H Function sensor AI8 (C20 only)
0. --- Input not active 0
1. HS2 Room sensor 1
2. HS2 Return 2
I Night setback VS1
0. No 0
1. Yes 1
J Room compensation VS1
0. No 0
1. Yes 1
KVS1-SV1 type
0. 0...10 V DC 0
1. 3-point 1
L VS1-SV2 (C20 only)
0. No 0
1. Yes 1
Configuration
Configuration implies the commissioning setting of all the parameters in the CORRIGO.
Parameters are set using script.
Configuration codes
There is also the option of setting parameters by means of two configuration codes.
This function is particularly useful and time-saving when a number of controllers are
to be configured in the same way.
The first thing to be shown when the configuration menu is opened is the setting of
the control function.
Using the arrow up button the two configuration codes will be displayed and the arrow
down button will give the parameters of the other configurations in script.
The code digits in the configuration code correspond to the script parameters below
in numerical sequence. This means that the first digit in CONFIG.CODE1 determines
which control function the controller is to work with. The second digit refers to heater
type etc.
Before the corresponding selection in the script parameters there is a digit which
corresponds to the code number in the configuration code. See the details below.
Tables for configuration code
There is also a special table to facilitate the choice of configuration code. This is
always supplied together with the CORRIGO instruction sheet.
In the table all the configuration parameters are shown as well as the selections that
can be made. Basic selections are marked in bold type.
By going through the parameters and filling in the figures beside the respective
selections the configuration code can be obtained without difficulty. This can also act
as a protocol of settings for CORRIGO.
Automatic restart after changing
When one or more parameters have been changed the controller will restart when the
user leaves the configuration menu.
To Next Page
Loading...
Need help?
General
