Holidays
Up to 24 separate holiday periods for a full year can be
set.
A holiday period can be any number of consecutive days from one and upwards. The dates
are in the format: MM-DD.
When the current date falls within a holiday period, the scheduler will use the settings for the
weekday “Holiday”.
Access rights
There are four different access levels, Normal level which has the lowest access and does
not require logging on, Operator level, Service level and Admin level which has the highest
access. The choice of access level determines which menus are shown, as well as which
parameters can be changed in the displayed menus.
The basic level only permits changes in Running mode and gives read-only access to a
limited number of menus.
Operator level gives access to all menus except Configuration.
Service level gives access to all menus except the submenus Configuration/In- and Outputs
and Configuration/System.
Admin level gives full read/write access to all settings and parameters in all menus.
Repeatedly press down-arrow when the start-up display
is shown until the arrow-marker to the left of the text-list
points to Access rights. Press RIGHT.
Log on
In this menu it is possible to log on to any access level
by entering the appropriate 4-digit code. The log on
menu will also be displayed should you try to gain
access to a menu or try to do an operation requiring
higher authority than you have.
Press the OK button and a cursor marker will appear at the first digit position. Repeatedly
press the UP button until the correct digit is displayed. Press the RIGHT button to move to
the next position. Repeat the procedure until all four digits are displayed. Then press OK to
confirm. After a short while the text on the line: Present level will change to display the new
log on level. Press the LEFT button to leave the menu.
Factory set passwords:
Admin: 1111
Service: 2222
Operator: 3333
Normal: 5555
To Next Page
Loading...
Need help?
General
