Reliance electric PSC PC-2 - Reset Switch; Interface Cable and Connectors

2-4
PSC Console PC-2
2.3.3 Reset Switch
As shown in Figure 2.1, there is a switch called "Reset Switch" at the left lower
corner on the rear side of the PSC Console. Pushing the Reset Switch with a thin
bar like needle will initialize the PSC Console.
2.3.4 Interface Cable and Connectors
Communication between the PSC Console and the PSC3000, PSC4000 or
PSC5000 System is performed through the interface cable and the connectors. The
power to the PSC Console is also supplied from the PSC3000/PSC4000/PSC5000
System through the interface cable and connectors.
ATTENTION: The interface cable is fixed to the PSC Console. Do not
attempt to remove the interface cable from the PSC Console by force.
Failure to observe this precaution could result in damage to, or
destruction of, the PSC Console of the interface cable.
!