Reliance electric PSC PC-2 - To Discontinue Modification of Attribute Data; To Scroll Attribute Data

4-10
PSC Console PC-2
4.4.3.4 To Discontinue Modification of Attribute Data
When you desire to discontinue modification of the attribute data, press the ENTER
key without entering any number; i.e., pressing the CLR ENTER keys
discontinues modification.
4.4.3.5 To Scroll Attribute Data
When you desire to monitor the attribute data by scrolling, use the following
procedure.
1) Enter the attribute data number from which you desire to start scrolling, by
pressing the following keys.
DATA 0 to 9 ENTER
The specified attribute data will be displayed.
2) Then, press the ENTER key only. The following attribute data will be shown in
the display.
3) Press the ENTER key repeatedly. The attribute data will be scrolled in the
numerical order of the attribute data numbers.
If any attribute data are already shown in the display, start the procedure from Step
2 above. Scrolling will start from the last entered attribute data, by pressing the
ENTER key.
If you press the CLR key, you can set or modify the attribute data.
Note that it is impossible to scroll the attribute data in the reverse order.