2
4
3
5
6
C
NU760_1_G3-FRA.qxd 9/11/05 17:18 Page 3.51
3.51
REAR SEAT FUNCTIONS (continued)
Accessing rear seats:
Lift control 2, handle 3 or pull
handle 6 in order to move the seat
forward and thus make space to
access the rear seats.
Leaving the vehicle from the rear
seats
Pull on handle 6 and push the seat
forwards. The seat will go forward,
creating a space to the door.
You can also increase the amount of
space by pulling down the seatback
using strap 5.
To fit a seat
The seats can be adjusted to your
preferred position on the rails.
Place the seat on the rails.
The seat automatically locks itself
onto the nearest notch when placed
on the rails.
Check that the seat is locked
correctly by moving it from left to
right and then forwards and
backwards.
Note: if the seat does not lock back
onto the rails correctly, pull on
strap 6 again to reload the system.
For safety reasons, carry
out these operations when
the vehicle is stationary.
When moving the rear seats,
check that the anchorage
points and rails are clean
(they should be free from
grit, cloths, toys, etc.)
For safety reasons, after a
seat has been fitted, check
that it is correctly locked
into place by moving it from
left to right and forwards and
backwards. If the fault is still
present, contact a RENAULT Dealer.
NU760_1_G3-ENG.qxp 27-Dec-05 18:41 Page 3.51 (Black/Process Black plate)
To Next Page
Loading...
