1
2
3
NU760_1_G1-FRA.qxd 10/11/05 10:09 Page 1.17
1.17
FRONT HEADREST
The headrest is a safety component, check that it is fitted and in the
correct position: the top of your head should be in line with the top
of the headrest.
To adjust the headrest
Pull the headrest upwards to the
desired height.
To lower the headrest
Press button 1 and lower the
headrest to the desired height.
To remove the headrest
Lift the headrest to its highest
position. Press button 2 and lift the
headrest until it comes free.
Note: when the headrest has been
removed, ensure rods 3 remain in
the same position.
To refit the headrest
If the rod setting has been altered,
withdraw the rods 3 as far as
possible by pulling upwards (check
their alignment and cleanliness) and
ensure that the notches are facing
forward.
Insert the headrest rods into the
holes (tilt the seatback backwards if
necessary).
Push the headrest downwards until
it clicks and check that it is properly
locked.
Press button 1 and push down the
headrest as far as it will go.
NU760_1_G1-ENG.qxp 27-Dec-05 18:37 Page 1.17 (Black/Process Black plate)
To Next Page
Loading...
