1
3
4
2
NU760_1_G1-FRA.qxd 10/11/05 10:09 Page 1.18
1.18
FRONT SEATS WITH MANUAL CONTROLS
We would advise you not to
recline the seatbacks too far
back to ensure that the
effectiveness of the seat
belts is not reduced.
Make sure that the seatback is
locked in place correctly.
No objects should be placed on the
floor (in the area in front of the
driver) as these objects could slide
under the pedal during braking
manoeuvres, thus obstructing its
use.
For safety reasons, carry
out any adjustments when
the vehicle is stationary.
To move a seat forwards or
backwards
Lift lever 1 to unlock the seat. When
the seat is in the required position,
release the lever and ensure that the
seat is locked in place.
To recline the seatback
Lift lever 4 and tilt the seatback to
the desired position.
To adjust the lumbar support on the
driver’s seat:
Pull handle 2.
To adjust the driver’s seat height:
Move lever 3 as many times as
necessary:
- upwards to raise the seat;
- downwards to lower the seat.
NU760_1_G1-ENG.qxp 27-Dec-05 18:37 Page 1.18 (Black/Process Black plate)
To Next Page
Loading...
